| Series | O-Series |
|---|---|
| Type of Pump & Motor | Orbital Motor |
| Flow Rate (CC Per Rev) | 40 |
| Part Number | 11186719 |
| Manufacturer | Danfoss Power Solutions |
| Motor Series | O-Series |
| Basic Motor | OMP X |
| Model Code | OMPX-040-NNN-B11-SO-A3-A11-C-E-B-1-N-N-NN-NNN-NNN-NNN-A-NN |
| Displacement | 40 cm3/rev |
| Design Number | X |
| Port Style | Side ported - offset manifold (4 x M8) |
| Check Valve | Yes |
| Gear Wheel Set | Standard |
| Front Bearing | Journal bearing |
| Rear Bearing | Journal bearing |
| Dust Seal | Integrated in shaft seal |
| Seal Kit | 11188319 |
| Packing | Single pack |
| Drain Port Style | Standard - End cover |
| Alternative Part Number | 1510342 |
| Port Size | G 1/2 |
|---|---|
| Shaft Size | Dia. 25 mm - M8 tap |
| Shaft Seal | HNBR - High pressure |
| Mounting Flange | 2 Bolt - A |
| Mounting Thread Dimension | Pilot dia. 82,5 x 8 [3,25 x 0,31] - B.C. dia. 106,4 [4,19]; Dia. 13,6 [0,53] |
| Shaft Style | Straight |
| Shaft Key | A8 x 7 x 32 mm (DIN 6885) |
| Port Dimension | G 1/2 |
| Drain Port Dimension | G 1/4 |
| Gerotor Width | 6.8 mm |
The Danfoss OMPX 40 orbital motor (part number 11186719) is a low-speed, high-torque gerotor motor from the Danfoss O-Series OMP X range, with a displacement of 40 cm³/rev. The X design carries a high-pressure HNBR shaft seal with an integrated dust seal, making it the more robust choice for contaminated or high-duty installations.
Mounting and shaft
A 2-bolt A-type mounting flange with an 82,5 mm pilot on a 106,4 mm bolt circle. The output shaft is a straight 25 mm diameter with an M8 tap and an A8 x 7 x 32 mm key to DIN 6885.
Porting
Work ports are G 1/2 BSP, side ported through an offset manifold with 4 x M8 fixings, and a G 1/4 drain port in the end cover. An integral check valve is fitted as standard.
Construction and sealing
Journal bearings front and rear with a standard gear wheel set. The dust seal is integrated into the shaft seal. Gerotor width is 6.8 mm. The matching service kit is seal kit 11188319.
Cross reference
Also listed under part number 1510342. If your paperwork shows that number, this is the motor you need.
Sizing
Work out the flow, speed and torque for your duty with our hydraulic calculator, browse the full orbital motors and steering range, or ask an EMPH engineer to confirm the right displacement.
